KB Source: https://support.americandynamics.net/#/knowledge-base/article/46433

The following firmware should be used when integrating the Illustra Flex Gen 4 and Illustra Pro Gen 4 with Tyco / Magos Radar:

MASS 3.23.x


ProductModelSoftwareDownload Link
Flex4 PTZIFS02-P07-ATA4
IFS02-P07-IIA4
IFS02-P07-OIA4
IFS04-P07-ATA4
IFS04-P07-IIA4
IFS04-P07-OIA4		Illustra.SS018.05.09.01.0033Illustra.SS018.05.09.01.0033.tar.gz
Pro4 PTZ CamerasIPS02-P24-OI04
IPS08-P25-OI04
IPS02-P07-RT04
IPS08-P25-RT04		Illustra.SS010.24.09.00.0004Illustra.SS010.24.09.00.0004.tar.gz



MASS 3.24.x


ProductModelSoftwareDownload Link
Flex4 PTZIFS02-P07-ATA4
IFS02-P07-IIA4
IFS02-P07-OIA4
IFS04-P07-ATA4
IFS04-P07-IIA4
IFS04-P07-OIA4		Illustra.SS018.24.09.01.0004Illustra.SS018.24.09.01.0004.tar.gz
Pro4 PTZIPS02-P24-OI04
IPS08-P25-OI04
IPS02-P07-RT04
IPS08-P25-RT04		Illustra.SS010.24.09.01.0006Illustra.SS010.24.09.01.0006.tar.gz

Firmware Upgrade Steps

  1. Make sure camera is standalone (not connected to Magos or VMS).
  2. Retrieve compatible Firmware files to your MASS version referencing table above.
  3. Upgrade camera firmware via WebGUI or Illustra Connect.
  4. Reset Camera to factory default after the upgrade/downgrade.
    • Network settings can be preserved.